If the same route with the same prefix length is learned via 2 different protocols, which route information will be entered into the routing table?
A packet sourced from a client device behind a source NAT configuration is received by the end device. What address does the packet appear to be received from when the end devices receives it?
Is 22.214.171.124 a public or private address?
What is the interface command used to place an interface into etherchannel 2?
Which of these are a protocol data unit in layer 4 of the OSI model?
What minimum PoE standard will a PoE switch need to be compatible with in order to use a PoE WAP which requires 30W of electricity to operate?
In order to manage a LAP directly, navigate to the AP’s IP in a web browser
What is the network identifier for the IP 10.7.12.122/21
Which AP mode does not handle client data and only provides location-based services?
What is the most compact representation of the following IPv6 address? 2001:db8:0000:0000:cafe:0000:0000:1234
If a route to the destination network 10.1.1.0/24 is learned from the below sources, which route information will be inserted to the routing table?
Where in the WLC GUI is FlexConnect configured?
You have a connection that needs gigabit connectivity over a distance of 200m, what cable type should you use for the lowest cost?
A Lightweight Wireless Access Point (LAP) is configured and operated independently, without the need of a Wireless LAN Controller (WLC).
Which of the following OSPF attributes do not need to match for a neighborship to form?
Which of these IPv6 addresses are a link-local address generated using modified EUI-64 method?
What will happen if the hello/dead timers do not match between 2 routers forming an OSPF neighborship/adjaciency?
In the TCP 3-way handshake, what response is expected to a packet sent with the SYN flag set?
Your company uses Cisco DNA Center to manage the network and just purchased and connected many new security cameras on their own VLAN. The cameras were successfully identified by the Identity Services Engine and placed into their own Security Group Tag and you can ping from the camera VLAN to the internet. The DVR is not able to connect to the cameras, choose the best answer for what could be the issue.
Is 172.20.12.5 a public or private address (RFC 1918)?
Which 2 of the following describe the distribution layer?
Upon a web server receiving a TCP packet with the SYN flag on port 80, what flag(s) will be set in the response packet?
What interface is used by a WLC to communicate with external authentication servers?
Your company is looking to set up a configuration management system for network devices. Management requires that the system support many legacy devices in the environment. This system will need to be able to push configuration changes out to devices and verify if the changes were applied successfully. Which configuration management system would you recommend?
What type of access point is centrally configured and managed?
While troubleshooting a separate issue, you run a packet capture on a workstation and find that many unicast packets are being received that are destined for IP address that are not assigned to this workstation. What could be causing this to happen?
What is the default priority assigned to a switch participating in RPVST+ ?
Which of these are not a feature of Cisco DNA
What is the maximum wattage of PoE power supplied under the 802.3at standard?
Which is the correct location and syntax for configuring a DHCP relay?
Which MAC architecture in a centralized AP deployment would allow wireless clients to still access the internet using a branch office’s internet connection if communication with the WLC is lost?
If a main and reflected wireless signal are received 180 degrees out of phase, what will happen to the received signal on the client device?
You are configuring a remote access VPN and want to minimize the amount of overhead in the data streams. Which protocol should you choose for the VPN to use?
Is 10.240.28.5 a public or private (RFC 1918) address?
How many connections are needed for a full mesh topology with 8 nodes?
You're asked to implement SNMP for all network devices and to have SNMP communications be encrypted to ensure sensitive data is not accidentally leaked. Which SNMP version(s) can be used?
How is a unicast frame handled that is received for an unknown destination MAC address?
An etherchannel is configured using LACP negotiation with 3 included interfaces on each switch. Both sides are configured in LACP passive mode. What will the result be?
Of the 3 configuration management solutions below, which does not require an agent on the managed device?
What is the command used to manually set the OSPF network type to point-to-point?
What is the name given to a hierarchical network topology that is related to a 3-tier topology where the core and distribution layers have been combined?
A virtual machine has direct access to the host machine hardware
What does the port-security feature limit?
What is the name of the IEEE standard used for tagging traffic across trunks to specify the VLAN ID the traffic is a member of?
What are the 3 non-overlapping channels in the 2.4GHz frequency spectrum of 802.11 ?
What is the default administrative distance of OSPF?
Which of the following could be the HTTP status code returned for a successful PUT request?
What keyword is used for level 4 syslog messages?
What is the network address for the IP 10.7.6.5/21 ?
Which of the following are not an HTTP method/verb used in a RESTful API?
All of your access points are part of the ‘default-group’ AP group and you’ve just created a new WLAN but it’s not being broadcasted. What is the likely solution to broadcast the SSID?
What is the default information used by an etherchannel to determine which bundled link traffic will be forwarded across?
What syslog level corresponds to an “Alert” level message?
What is the default amount of time an entry will stay in the CAM table without a frame received?
In terms of security, what does AAA stand for?
What is the default Administrative Distance of a static route?
Company policy states that all voice traffic should have the DSCP value set to EF to ensure voice services are not degraded during times of congestion. When running a packet capture you find that both user data and voice traffic have a DSCP value of 46. What do you recommend?